|
AS-i 3.0 Master/Scanner for
Allen-Bradley ControlLogix
|
|
|
See also:
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
AS-i Master for
Allen-Bradley ControlLogix
2 AS-i Master
AS-i 3.0 from ID no. 12704
(see lateral Label)
|
|
Art. no. BW1611 complete set: AS-i 3.0 Master BWU1488 plus accessories BW1563
|
Art. no. BWU1488 AS-i 3.0 Master for Allen-Bradley ControlLogix
|
Art. no. BW1716 AS-i Master for Allen-Bradley ControlLogix
Class I Div. 2 (Group A, B, C & D, T-Code 4)
|
Function
The Bihl+Wiedemann AS-i Master for ControlLogix of Allen-Bradley has 2 AS-i masters according to the new specification. A fast and easy commissioning can be accomplished with the use of two push-buttons and the display.
AS-i I/O data and status information is mapped into the PLC processor's I/O data.
AS-i Scope
Diagnostics, which go far beyond the standard diagnostics facilitate the simple detection of the occassionally occuring configuration errors and further irritations towards the AS-i communication. So in case of an error the down time of machines can be minimized or you can initiate preventive maintenance.
Commissioning and monitoring
The AS-i Master can be commissioned respectively programmed with the help of the software "AS-i Control Tools". Commissioning, debugging and setting up the system without the software can only be accomplished with the use of two push-buttons, the display and the LEDs directly on the system.
|
Art. no.
|
BWU1488 / BW1716
|
|
Operating current
|
approx. 70 mA out of AS-i
approx. 390 mA out of power supply 5,1 V DC
approx. 150 mA out of power supply 24 V DC
|
|
Operating voltage
|
AS-i voltage 30 V DC
|
|
AS-i cycle time
|
150 μs*(Number of slaves + 2)
|
|
Displays
|
|
|
LED display
|
displaying slave addresses and error messages
|
|
LED green (PWR)
|
power on
|
|
LED green (OK)
|
communication and control information
|
|
LED red (Fault)
|
configuration error
|
|
LED green (U AS-i)
|
AS-i voltage OK
|
|
LED green ( AS-i act)
|
AS-i normal operation active
|
|
LED green (prg enable)
|
automatic address programming enabled
|
|
LED yellow (prj mode)
|
the master is in configuration mode
|
|
Push-buttons
|
2 (mode/set)
|
|
Voltage of insulation
|
≥ 500 V
|
|
EMC directions
|
EN 50 082, EN 50 081
|
|
Ambient operating temperature
|
0°C ... +55°C
|
|
Storage temperature
|
-25°C ... +85°C
|
|
Housing
|
housing for DIN-rail mounting
|
|
Dimensions (L, W, H)
|
146 mm, 35 mm, 132 mm
|
|
Protection category (DIN 40 050)
|
housing IP20
|
|
Weight
|
420 g
|
