AS-i OEM Slave with serial Interface

See also:
	PDF file of this data sheet

AS-i OEM Slave with serial Interface

Developing platform for
client specific electronics,
specific serial protocols

Single slave

(A/B slave possible with appropriate protocol)

Additional 2 holes for assembly angles

The AS-i OEM Slave with serial interface is a developing platform with its help client specific electronics can be connected to AS-i. With the help of the AS-i profile S-7.3 (other profiles on request) a greater data volume can be transferred via AS-i easily. The data can be operated easily in the AS-i master via the command interface from a PLC.

Customer-specific special orders are possible on short notice.

Technical data		Programming (Bit-setting) Data range Analog input data image, channel 1 Parameter bit Bit function P0 not used P1 not used P2 not used P3 not used Programming: Address preset 0 changeable via bus master or programming devices IO code 7 ID code 3 ID2 code 8
Connection	screw terminals
Connection	circuit board installation
Customer interface	TTL, RS 232 or RS 485, galvanical separated to AS-i
Baud rates	Up to 19200 bit/s
Length of connector cable	I/O: max. 1,5 m
Operating voltage AS-i part	Via AS-i
Operating voltage customer interface	20 ... 30 V DC, 80 mA out of customer electronic, 5 V supply on request
Operating current AS-i part	≤ 100 mA
EMC directions	EN 61 000-6-2, EN 61 000-6-4
Ambient operating temperature	-25°C ... +70°C
Storage temperature	-40°C ... +70°C
Protection category (EN 60 529)	IP20 (build in)
Allowable shock and vibration stress	≤ 15 g, T ≤ 11 ms 10 ... 55 Hz, 0,5 mm amplitude
Dimensions (L, W, H)	73 mm, 37,5 mm, 10 mm

PDF file of this data sheet

AS-i OEM Slave with serial Interface

See data sheet for more details.