ASi-5 Digital Input Module in IP67, with 8 x M12 sockets, 8 digital inputs, single wiring, input voltage/sensor supply out of ASi, periphery connection via 8 x M12 sockets, 5 poles, ASi connection via M12, 1 ASi-5 slave
IP67, 8 x M12, ASi-5
8 x M12
"IP20": Protected against solid foreign bodies having a diameter of 12.5 mm or larger and against finger contact, not protected against water.
Protected against solid foreign bodies having a diameter of 1.0 mm or larger, protected against access with a wire, no protection against water.
Protection against dust in damaging amounts, complete protection against contact, protection against splashing water in any angle.
"IP65": Dust-tight, full protection against contact, protection against spray water (jet) from any angle.
Dust-tight, full protection against contact, protection against temporary immersion.
"Control cabinet": Cost-optimized modules whereby the supply voltage for the sensors and actuators is connected via additional patch terminals. Optimal application in the main control cabinet.
"Decentralized control cabinet": Ideal for use in decentralized control cabinets. 3-wire sensors or actuators can be connected directly to terminals in the module
without additional patch terminals or the module has an extremely flat design.
Flat design, installation in cable duct possible
Modules with a flat housing design and with cables which exit the sides make these ideal for installation in cable ducts, cable channels, cable troughs, cable rails or cable trays. Please note the respective housing depth for your particular installation.
Inputs Safety, SIL 3, Cat. 4
Safety signal inputs
either as a single–wiring, Y–wiring or mixed-wiring.
M12 (5 poles)
M8 (3 poles)
Input voltage (sensor supply)
inputs are supplied by ASi or by AUX (auxiliary 24 V power). If supplied by ASi, inputs shall not be connected to earth or to external potential.
out of ASi
Output voltage (actuator supply)
Electronic outputs are supplied by ASi or by AUX (auxiliary 24 V power). If supplied by ASi, outputs shall not be connected to earth or to external potential.
For relay outputs the relay contacts are initiated from ASi. The load circuit is powered externally as specified in the data sheet.
PUR line, oil resistant. Further connection options are available on request.
M12 cable socket, angled
M12 cable socket, straight
M8 cable socket, straight
round cable/connecting wires
profile cable branch
push in terminals
2 x round cables/connecting wires 2,5 mm²
8 x M12 sockets, 5 poles
Under normal conditions (no bus termination or repeater), the permissible total length of the ASi segment is max. 100 m. The calculation should take into consideration that the length of the connection cable (round cable) for each connected passive distributor must be doubled.
In the case of the active distributors (ASi slaves) however only the one ASi profile cable is counted.
The connection to ASi as well to AUX (auxiliary 24 V power) is made via yellow resp. black ASi profile cable with piercing technology or via M12 socket (in IP20 via clamps).
Line protection: If the module is supplied via a M12 connection with A or B coding, it may only be used with a current load of max. 4 A per pin in acc. with IEC 61076-2-101 and IEC 61076-2-109. A fused tap is recommended. There is no such limitation for modules supplied via piercing contacts.
ASi via M12
AB Slave (max. 62 AB Slaves/ASi network), 2 AB Slaves (max. 31 modules with 2 AB Slaves), Single Slaves (max. 31 Single Slaves/ASi network), ASi-5 Slave (max. 62 ASi-5 Slaves/ASi network), mixed use allowed. For modules with two slaves the second slave is turned off as long as the first slave is addressed to address "0". Upon request, slaves are available with specific ASi Slave profiles.