BWU4942ASi Cable Duct Motor Module, IP54, M8 and M12 for 24V motorized rollers, 2M/4I
ASi cable duct motor module in IP54, with 2 x M8 cable sockets and 2 x M12 cable sockets for 2 x 24 V motorized rollers Itoh Denki (PM500XE/XP, PM605XE/XP), 4 digital inputs, input voltage/sensor supply out of ASi, output voltage/actuator supply out of AUX, internal line protection, separately for each motor 3,5 A (slow-blow fuse), flat design, installation in cable duct possible (installation depth ≥19 mm), periphery connection via 2 x M8 sockets, straight, 5 poles (motors) and 2 x M12 cable sockets, straight, 5 poles (sensors), cable length of motor connections 0,4 m, cable length of input connections 1 m, ASi connection via profile cable and piercing technology, 1 AB Adresse
"SEW MOVIMOT®": Motor module to control geared motors with frequency inverters.
"NORD": Motor module to control geared motors with frequency inverters.
Brake chopper for 24 V motorized rollers: For limiting the voltage feedback, suitable for all 24 V motorized rollers.
|Itoh Denki (PM500XE/XP, PM605XE/XP)|
|Number of Drives||2|
Input voltage (sensor supply)
inputs are supplied by ASi or by AUX (auxiliary 24 V power). If supplied by ASi, inputs shall not be connected to earth or to external potential.
|out of ASi|
Output voltage (actuator supply)
Electronic outputs are supplied by ASi or by AUX (auxiliary 24 V power). If supplied by ASi, outputs shall not be connected to earth or to external potential.
For relay outputs the relay contacts are initiated from ASi. The load circuit is powered externally as specified in the data sheet.
|out of AUX|
PUR line, oil resistant. Further connection options are available on request.
|2 x M8 snap-in cable sockets, straight, 5 poles + 2 x M12 cable sockets, straight, 5 poles|
Under normal conditions (no bus termination or repeater), the permissible total length of the ASi segment is max. 100 m. The calculation should take into consideration that the length of the connection cable (round cable) for each connected passive distributor must be doubled.
In the case of the active distributors (ASi modules) however only the one ASi profile cable is counted.
|M1, M2: 0,4 m; I1/I2, I3/I4: 1 m|
AB address (max. 62 AB addresses/ASi network), 2 AB addresses (max. 31 modules with 2 AB addresses), Single addresses (max. 31 Single addresses/ASi network), ASi-5 address (max. 62 ASi-5 addresses/ASi network), mixed use allowed.
|1 AB address|
How to get started with Bihl+Wiedemann products
How to easily implement your ASi installation
How to troubleshoot an existing ASi installation
Brake chopper 24 V, IP67» show product details
Magnetic holders for substructure Modules» show product details
ASi Substructure Module in IP67 for cable duct ASi motor modules» show product details
ASi-5/ASi-3 Address Programming Device» show product details