Logo Bihl+Wiedemann GmbH

The Motor Module for SEW frequency inverter optimized for use in the cable duct!

The motor module by Bihl+Wiedemann for SEW frequency inverter (BW3406) has been optimized for the use in the cable duct. This type of installation is made possible by the very flat (W × H × D: 90 × 60 × 18 mm) design.  


Fig.: Cable Duct AS-i Motor Module, IP54, M12 for SEW frequency inverter, 2I (BW3406)

The new Cable Duct AS-i Motor Module in detail

  • AS-i Slave for SEW frequency inverter
  • Control of a MOVIMOT® drive: start/stop, rotation direction, speed, 2 different acceleration ramps (new)
  • Optimized for installation in the cable duct by very flat design of the motor module (W × H × D: 90 × 60 × 18 mm) and passive distributor (W × H × D: 60 × 45 × 19 mm)
  • Mixed in- and output slave
  • Sensors supplied out of AS-i
  • Motors supplied out of AUX (24 V auxiliary power)

 

Of course, we also offer modifications to adapt to drives made by other manufacturers. Just contact us.

Questions about our products and solutions?

We would be happy to assist you.